ChaseDream
搜索
12下一页
返回列表 发新帖
查看: 2244|回复: 13
打印 上一主题 下一主题

GWD 26 32-35 题答案 谁有发一下啊! 是这个月的jj 原题见下

[复制链接]
跳转到指定楼层
楼主
发表于 2012-7-12 17:08:26 | 只看该作者 回帖奖励 |倒序浏览 |阅读模式
摘自jj总结 但是这道题没附上答案啊! 麻烦哪位大神见过 发下答案 原文如下
GWD26-Q32 to 35
In 1975 Chinese survey teams remeasured Mount Everest, the highest of the Himalayan mountains. Like the British in 1852, they used the age-old technique of “carrying in” sea level: surveyors marched inland from the coast for thousands of miles, stopping at increments of as little as a few feet to measure their elevation, and marking each increment with two poles. To measure the difference in elevation between poles, surveyors used an optical level—a telescope on a level base—placed halfway between the poles. They sighted each pole, reading off measurements that were then used to calculate the change in elevation over each increment. In sight of the peaks the used theodolites telescopes for measuring vertical and horizontal angles—to determine the elevation of the summit.The Chinese, however, made efforts to correct for the errors that had plagued the British. One source of error is refraction, the bending of light beams as they pass through air layers of different temperature and pressure. Because light traveling down from a summit passes through many such layers, a surveyor could sight a mirage rather than the peak itself. To reduce refraction errors, the Chinese team carried in sea level to within five to twelve miles of Everest’s summit, decreasing the amount of air that light passed through on its way to their theodolites. The Chinese also launched weather balloons near their theodolites to measure atmospheric temperature and pressure changes to better estimate refraction errors. Another hurdle is the peak’s shape. When surveyors sight the summit, there is a risk they might not all measure the same point. In 1975 the Chinese installed the first survey beacon on Everest, a red reflector visible through a theodolite for ten miles, as a reference point. One more source of error is the unevenness of sea level. The British assumed that carrying in sea level would extend an imaginary line from the shore along Earth’s curve to a point beneath the Himalaya. In reality, sea level varies according to the irregular interior of the planet. The Chinese used a gravity meter to correct for local deviations in sea level.----------------------------------------------------------------
Q32:  It can be inferred from the passage that refraction would be most likely to cause errors in measurements of a mountain’s elevation under which of the following conditions?
A.    When there are local variations in sea level
B.    When light passes through humid air
C.    When theodolites are used relatively far from the mountain peak.
D.    When weather balloons indicate low air temperature and pressure.
E.    When sea level has been carried in to within five to twelve miles of the summit.------------------------------------------------------------------
Q33: Which of the following best describes the purpose of the sentence in lines 23-25 (“The Chinese…the British”)?
A.    Introduce a definition
B.    Signal a transition in focus
C.    Summarize the preceding paragraph
D.    Draw a contrast between two different theories.
E.    resent information that contradicts the preceding paragraph.-----------------------------------------------------------------
Q34: Which of the following is NOT mentioned as a possible source of error in surveying mountain elevation?
A.    Mirages
B.    Refraction
C.    Inaccurate instruments
D.    Variations in sea level
E.    Uncertainty about the exact point to be measured---------------------------------------------------------------
Q35: The primary purpose of the passage is to
A.    provide details about improvements to a process
B.    challenge the assumptions underlying a new method
C.    criticize the way in which a failed project was carried out
D.    call for new methods to solve an existing problem
E.    explain the theory behind a new technique
收藏收藏 收藏收藏
沙发
发表于 2012-7-12 17:14:02 | 只看该作者
dbca
板凳
 楼主| 发表于 2012-7-12 17:14:37 | 只看该作者
再加GWD9 21-23的题和答案呗!谢谢了!
地板
 楼主| 发表于 2012-7-12 17:15:29 | 只看该作者
dbca
-- by 会员 非同反想 (2012/7/12 17:14:02)


麻烦再看一下2楼的那个被! 这个是标准答案?
5#
发表于 2012-7-12 17:27:16 | 只看该作者
我做了是cbda吧?不清楚,求答案
6#
发表于 2012-7-12 17:35:36 | 只看该作者
备考资料贴中有。。。 可以找到 http://forum.chasedream.com/GMAT_Preparation/thread-519351-1-1.html
"以下提供附件。第一个附件是排版最好、编号统一的GWD/TN-24,压缩文件里包括了24套题的PPT+WORD、答案表和分类详解"

第一个貌似是争议题。。 我做的也是C
7#
 楼主| 发表于 2012-7-12 17:36:02 | 只看该作者
我做了是cbda吧?不清楚,求答案
-- by 会员 fianny (2012/7/12 17:27:16)

又做了一遍 感觉是dbca 原文都有提过
要不你再仔细看看吧! 好纠结的jj啊!
8#
发表于 2012-7-12 19:03:07 | 只看该作者
不纠结,原文确定,题目可不确定,没有狗主来认领原题,把文章好好读读哈,争议题就不要管了
9#
发表于 2012-7-13 01:39:59 | 只看该作者
做了一遍我答案是dbca
10#
发表于 2012-7-13 04:18:31 | 只看该作者
CBCA
真心认为第一题是C。D项关键词虽然文章都提到,但是问题本身说的是最可能导致测量错误的原因,而D说的是检测到温度和压力低。回到原文,在提到气球前说的是测量错误的原因在于很多LAYERS导致光线折射,真心觉得LAYERS这个词是重点,如果压力低的话就不会很多LAYERS哈,没有很多LAYERS就不会有很大的误差哈。
您需要登录后才可以回帖 登录 | 立即注册

Mark一下! 看一下! 顶楼主! 感谢分享! 快速回复:

手机版|ChaseDream|GMT+8, 2025-9-9 16:03
京公网安备11010202008513号 京ICP证101109号 京ICP备12012021号

ChaseDream 论坛

© 2003-2025 ChaseDream.com. All Rights Reserved.

返回顶部